Why we feel Live-Silver is the best colloidal silver on the market. In 2008 we added a health giving frequency to our products and in doing so we found it eliminated the black staining that has plagued silver products of all kinds throughout history! As the discoloration of the skin is due to this blue-black stain, we have eliminated the one complaint against ionic colloidal silver. This is a major breakthrough. There are many products being marketed as “colloidal silver”. They are not the same and vary drastically in important ways. Many are not a colloid, but rather a silver salt or other chemical. Many use a protein such as milk or gelatin to keep the silver in suspension. These often require refrigeration or they will spoil. Their shelf life is short. Of greater concern is the fact that the silver is in chemical form and not readily available. Furthermore, most of them are toxic and the labels often say: “Keep away from children” or “Keep out of eyes” or they prescribe a very small dosage which is not effective for treating any condition, even a cold. The reason for these warnings is that they are a cheap product that is toxic. Then again they may say; “Shake well before using”. This is because they are not ionic and the particle size is too large to stay in suspension.

The Laser Beam clearly shows that Live-Silver is far superior. The higher and brighter the beam the higher the PPM and quality.

There are still other differences. Many are produced electrically using table salt as an electrical conductor. This produces largely silver chloride, which is not soluble, not effective and therefore accumulates in the body and produces a discoloring of the skin and the parts per million is meaningless.

These are the products most doctors were using before antibiotics were available and gave silver its bad name. While high quality ionic colloidal silver was available, it is slow and hard to produce. The pharmaceutical companies were supplying doctors with their cheap imitations, just as most suppliers are today. These products are not a colloid. They call themselves a colloid because they know the true product IS a colloid.

Some of our competitors have stated that our products are not a colloid but rather a solution because our particle size is so small. This is definitely not true as is proven by the standard test for a colloid of shining a laser light through the liquid. Our products very clearly show the light reflected from the particles as no solution can do. See the picture above

Our products are all 97% ionic and so pure they are as clear as water and have almost no taste.

We produce our silver by passing a direct electrical current between positive and negative silver electrodes of 99.9 percent pure silver through distilled water. Competitors say this will not work because distilled water transmits almost no electricity. While they claim their products are ONLY pure silver and pure water in a colloid, a simple test for dissolved solids with a common Hanna meter for dissolved solids shows definite dissolved solids in many of their products. A Hanna meter will read some colloids up to about 9 PPM, but most of these competitive products show more than the silver. There is some chemical added for conductivity, even though they deny it. We have developed patented equipment which produces a truly pure colloidal silver without ANY additives. We add no chemicals, only health giving frequencies (four). Water has an amazing way of holding frequencies and transmitting them for healthful purposes. We then break each of the particles thus produced down into particles of one tenth the original diameter, producing 1,000 particles out of each one! (10X10X10). The original particle had a charge of +1. This leaves 999 particles with no charge. This is not ionic. Therefore we run these particles through another process to charge them. This produces a product having 1,000 times the normal charge and each particle has an effect similar to each original particle, considerably increasing the effectiveness.

It is important to understand the difference between parts per million and parts per cubic centimeter. Parts per million (PPM) means how much silver is in one litter of pure water in milligrams. One block of silver weighing 20 milligrams dropped in one litter of water will be 20 PPM but will not be of any use as a heath benefit. Although it will be 20 PPM, it will only be I part per litter, being only one part. However, if we break that one 20 milligram part down into 100 million parts, it becomes very useful for health purposes. That is why parts per cubic centimeter is much more important than PPM.

Do not believe the claims and pictures of multi million dollar test equipment by colloidal silver producers. Before you believe their claims of university testing, look closely at their documents. You will find the information above the certification signature has been removed and replaced with language no scientist, professor or lab technician would use. Try calling or writing the university and the specific professor whose signature appears on the document for verification. It just is not so.
When you buy Live-Silver you are sure of a product in which neither time nor money have been spared to give you the finest possible product, as verified by the “Kill Time Chart” showing the kill time of Live-Silver compared to five other leading silver products. Check the entire article on Kill Time and Toxicity.
Click Here to find out more about Live-Silver

Product Kill Time                                                            Minutes   Seconds                    Toxicity ASAP 1 44 Contains Silver Cloride Sovereign Silver 1 42 No Meso Silver 1 41 No (Brown) Medical Journal MSP 500 PPM 1 40 Medium Natural Path 500 PPM 1 39 Medium Live-Silver 1 10 No